LED Lighting for Channel Letters and Advertising Signage

LED modules for front-lit, backlit and halo channel letters, 12V, 4–25 cm lightbox depths, IP65, 170° beam, 3-year warranty. GMH, Jiangmen, since 2008.

GMH LED modules lighting an acrylic channel letter sign face with uniform 170 degree illumination
LED modules give uniform light across a channel letter face.
Short answer

Channel letters are individual three-dimensional letters or logos, usually with an acrylic face and metal returns, lit from inside by rows of LED modules. GMH supplies the LED modules, strip lights and 12V power supplies that illuminate front-lit, backlit and halo-lit signs, with IP65/IP67 options for outdoor use and a 3-year module warranty.

Scope of supply in this sector

We supply the LED lighting components inside signs, not the finished signage. Sign manufacture, acrylic fabrication, installation and mains electrical work are done by the sign maker or installer.

Requirements

Module voltage12V DC low voltage
Letter depth4–25 cm, matched to module series
Beam angleUp to 170° for even faces
Outdoor protectionIP65 or IP67
ColourFixed CCT or RGB, binned per batch
Module warranty3 years

Materials we machine for this sector

  • Injection-moulded LED modules
  • 12V LED strip and silicone neon flex
  • 12V switching power supplies 36W–350W
  • Acrylic faces and metal letter returns (supplied by sign maker)

Applicable standards

  • CE, FCC and RoHS on applicable LED series
  • ISO 9001 quality management
  • IP65/IP67 ingress protection ratings
  • Local electrical codes for installation (installer responsibility)

Typical parts

  • Front-lit channel letter modules
  • Backlit and halo-lit modules
  • Sign outline neon flex
  • Lightbox LED modules
  • 12V power supplies

Quality risks specific to this sector

These are the failure modes we see most often in this industry. They are listed because knowing them before design review is cheaper than discovering them at first article.

  • Bright spots from under-spacing modules on deep letters
  • Colour banding when LED batches are mixed
  • Water ingress in exposed signs when IP67 is not specified
  • Voltage drop on long low-voltage runs
  • Overloaded power supplies when 20% headroom is ignored
Signage & Channel Letters

Compliance and capability questions

What LED modules suit a 10 cm deep channel letter?

A module series rated for that side-height range with a wide beam angle, typically around 170°, gives even face lighting without excessive module counts. Tell us the letter depth and face finish and we will recommend a series and spacing.

Do you make the finished signs?

No. We supply the LED modules, strips and power supplies that go inside the sign. Fabrication and installation are handled by the sign maker.

Which protection rating for an outdoor sign?

Covered outdoor signs are usually fine with IP65. Signs that take direct rain or pressure washing should use IP67 modules and an IP67 power supply.

Tell us your sign project, get a product recommendation

Share your sign design — letter depth, face material, indoor or outdoor — and we will recommend the right LED modules, strip, power supply and protection rating, with a quotation. No obligation.